LAYER ·

FORCE
LAYER · FROM ABOVE
WEAKSTRONG

Spec

Read from the CSS this page runs on. One slider with three values: which of six layers, and where on it, across and along. In the box on the left the handle moves freely over a layer, pressing a dent into the mesh where it is, the way a knob moves over a colour wheel. Push it into a corner of the layer and it slips onto that edge of the box: a line you can ride up or down through the layers. Pull it inward and it steps onto the face of the layer you stopped at. On the right, the same layer seen from straight above, for fine work. The layer, the point and the force read in the corner, always on screen.

Box and layers

Field
BoxNone drawn: the layers stand in isometric view on their own; the four upright edges of the space they fill are lines you can ride, shown only when hovered or ridden
Layers
Layer in useDrawn at full strength; the others fade to 25%, the neighbours a little stronger
DentWhere the handle is, the mesh sinks up to 26px in a soft round dent, deepest while held
ColourEach strand coloured by how far it is pressed down, weak to strong

Handle and lines

Handle6px white dot with a dark rim, in a 10px ring; it sits on the mesh, in its dent
On a faceMoves freely: across and along the layer, to two decimals
Onto a lineWithin 0.18 of a corner, the handle slips onto that upright edge; the edge lights white with a tick at each layer
On a lineUp and down only, through the layers; it settles on the nearest one when let go
Back to a faceMove 16px inward off the line and the handle steps onto the face of that layer
ThreadsTen threads hang between layers, each from a connection point on one layer to the same point on a layer one or two below; 0.6px white, brighter on the layers in use
Onto a threadBring the handle within 0.05 of a connection point on its layer and it catches the thread; or press the thread itself
On a threadUp and down between the two layers it joins; pull 16px off sideways near either end to step onto that layer; let go and it settles on the nearer end
From aboveThe panel on the right shows the layer in use flat, its connection points ringed with a triangle pointing the way the thread goes; dragging there moves the handle at 0.7 speed, for fine work; a press there jumps it to that point. Both handles are the same point

Readout

WhereMono 500 9px: the layer out of six, and whether the handle is on a face or a line
PointMono 600 17px: across, along, from 0 to 1
ForceHow hard the mesh is pressed where the handle is, 0 to 100%
LegendBottom right, a 3px bar from weak to strong

Colour

Space
Weak
Strong

States

HoverOver the layer in use, or the flat view, a small cross marks the point under the pointer; near an upright edge, that edge lights; over the handle, its ring opens to 12px
PressedThe dot tightens to 4.5px and the dent deepens; the point inverts, black on white
DragThe ring opens to 13px and follows; the mesh dents under it as it goes, with no lag
Let goStays where it is on a face; on a line, settles on the nearest layer
Keyboard and wheelArrows move across and along by 0.05; Page Up and Down, or a scroll, change the layer